Do you have any questions that I can help you with?
Do you have any questions that I can help you with?
Do you have any questions that I can help you with?
Do you have any questions that I can help you with?
Towtector Installation
Guide
|
*Note
- 3" to 4" of ground clearance is a MUST for Towtector to work* |
| |
 |
*TOWTECTOR® SHIELD EASILY ATTACHES TO BALL MOUNT
ON TOW VEHICLE*
1-3/4" of space required on ball mount to
install Towtector. |
|
|
TOWTECTOR- SHIELD INSTALLATION INSTRUCTIONS
Open
Towtector Box and lay Towtector parts on a piece of carpet (or
something similar). Set
all pieces on their top.
(See Photo) Make sure that
all 3 towtector sub assemblies have face side towards you and
all bolt holes are to the middle.
Slide each end sub assembly into
center sub assembly and insert (4) 5/16” x 2 ½” stainless steel
carriage bolts. Make sure that
the carriage head of the bolt is to the face side.
Put flat washer and nut on back side of assembly.
Align towtector and make sure it is straight and flat.
Tighten bolts very securely.
Please check center sub-assembly bolts to make sure they are secure
after usage!!! |
Click on the Picture below for a
larger image:
|
| |
|
Loosen Bolt on Towtector Shield
mounting and slide the Towtector onto the ball mount.
Install ball mount into receiver hitch and install pin (not
included).
Then adjust Towtector on ball mount to desired location.
Tighten bolts with ¾” wrench.
NOTE:
It
is recommended to mount Towtector as close to the vehicle as
possible without hitting the vehicle.
|
|
 |
|
Wall
Storage Bracket
Included is Wall
Storage Bracket and lag bolts.
Please fasten firmly to wall for safe
storage
of your Towtector. |
|
Click Here to Return to Main Towtector Page
Click Here to
Return to Main Towing Page
| 
